Hino Workshop Manual 500 Series FT1J, GT1J with J08C (S1-YFTE05A) AUSTRALIA :

This workshop manual has been prepared to provide information on electrical circuits for the following Hino Vehicles. Chassis workshop manuals Hino 500 Series - Applicable for FT1J, GT1J series.

Chassis Workshop Manual S1-YFTE05A

FOREWORD
GENERAL INTRODUCTION (CHASSIS)
CLUTCH MAIN UNIT (CS350)
CLUTCH CONTROL (CLUTCH SERIES: CS350)
TRANSMISSION MAIN UNIT (LX06S)
TRANSFER MAIN UNIT (MA12C)
P.T.O. (POWER TAKE-OFF) (TRANSMISSION SERIES: LX06S)
TRANSMISSION/TRANSFER CONTROL
PROPELLER SHAFT (LD0932 & LF0932)
DIFFERENTIAL EQUIPMENT (LOCKING TYPE DIFFERENTIAL GEAR)
DIFFERENTIAL CARRIER (SH13)
DIFFERENTIAL CARRIER (SH16)
DIFFERENTIAL CARRIER (SS12)
DIFFERENTIAL CARRIER (SS15)
BRAKE EQUIPMENT (MODELS: WITH AIR OVER HYDRAULIC BRAKE)
SERVICE BRAKE
ABS (ANTI-LOCK BRAKE SYSTEM)
ES START (EASY & SMOOTH START SYSTEM)
EXHAUST BRAKE
STEERING EQUIPMENT
SR02STEERING UNIT
POWER STEERING
FRONT AXLE (DIFFERENTIAL GEAR SERIES: SS12)
FRONT AXLE (DIFFERENTIAL GEAR SERIES: SS15)
REAR AXLE (DIFFERENTIAL GEAR SERIES: SH13)
REAR AXLE (DIFFERENTIAL GEAR SERIES: SH16)
WHEEL & TIRE
SUSPENSION
CHASSIS FRAME
CAB
ELECTRICAL EQUIPMEMT
ELECTRIC WIRE
BRAKE CONTROL (AKEBONO BRAKE MAKE)
BRAKE CONTROL (ES START)